Fast RGH 2 glitcher chip. Compatible with Phat, Trinity and Corona Boards.
has some changes like the new jtag programming port without connector,
and a new range of capacitor selections for CPU_RESET and PLL_BYPASS
The device comes with a dual ground cable
(red/black, both should be tied to ground) and also a 6 pin header (it
does not include the bulky long programming cable).
In order to
program the Stinger you can modify your Nandflasher or use another
programmer like NandX, check the images for information on how to
connect the stinger for programming.
Compatible with Phat & Slim (Trinity & Corona)
Embedded 48MHZ High Precision Oscillator
Dual Ground Cable included
Installs with the same diagrams/solder spots than Stinger 3.
x4 CPU_RESET capacitor options (can be combined)
4 PLL_BYPASS capacitor options (can be combined)
Alternate P40 (cpu_reset) pad with a 10 ohm resistor
Clock Selection Jumper
Selector Jumper for Phat or Slim
Selector Jumper for Phat RGH1 model (if programmed with phat_max.xsvf file)
ROL Pad (to show glitch status on front panel led on Phat consoles)
Maximus has reviewed and refreshed all the information on
www.360nandflasher.com, on the top of the page there is an Information
table with all the topics on how to connect stinger to nandflasher, how
to program stinger, how to use sdtool, etc. All information related to
Stinger 3.0 applies also for this new Stinger.
The support for this device is avalible under the 360nandflasher product page: http://360nandflasher.com
NOTE: All Maximus Stinger 4 shipps preprogrammed for Xbox 360 Slim.
The Stinger v4.0
Programming Cable (dont confuse this with a programmer)
Please note the chips can be reprogrammed using NANDFLASHER (updated to nandpro 3.0) or any JTAG cable.